Safety Guidelines

Do:

• Use proper rigging equipment
• Check load capacity of mounting points
• Ensure proper cooling and ventilation
• Test all fixtures before the event

Don't:

• Overload circuits
• Block ventilation openings
• Use damaged cables

Installation Steps

Step 1: Planning

Create a lighting plot showing fixture positions and power requirements.

Step 2: Rigging

Install truss and mounting hardware. Verify all connections are secure.

Step 3: Fixture Installation

Mount fixtures to truss using appropriate clamps. Ensure safety cables are attached.

Step 4: Cabling

Run power and DMX cables. Use cable management to keep runs neat and safe.

Step 5: DMX Configuration

Set DMX addresses on each fixture and configure your controller.

Step 6: Programming

Create lighting scenes and test all fixtures.